Cone Crusher

Shanxi 100t / h iron ore crushing production line

Rich iron ore resources in Shanxi, but the majority were depleted iron ore, our customers all the iron ore for the ultra-poor magnetite, low grade, but easily mined. According to the customer, such as his individual mines, Lingqiu surrounding cities and counties large and small, have hundreds of all hillside open air mining, mining depth is generally not more than 50m.

Customers from 2006 began to invest in local mining iron ore resources, such iron-bearing rocks of easy, fragile, easy to wear, mining and production costs are lower, and achieved good economic profits. 2008 due to the impact of the global financial crisis,

Broken mines will open open stop-efficiency has been raised not up. Currently the local individual mines in widespread use broken two jaw crusher configuration, and then into the hammer breaking. This three-stage crushing process, although simple, initial investment less CHEN Ben, but later the high maintenance costs, most people can not accept that a hammer breaking inefficient. Often two days wear parts to be replaced, and a replacement, tend to waste the time of day. In view of this situation, YIFAN machinery to help the customer do a detailed analysis, pointed out where the problem is, and to propose a reasonable solution.

The YIFAN machinery engineers to analyze: hammer crusher is one of the most low-cost crushing equipment, but can only be used in the production capacity is relatively small mine. This is because the case of small capacity, hammer crusher hammerhead loss and replacement costs caused by pressure and maintenance more difficult, owners can accept. However hammer crusher as the most inexpensive value crushing equipment, the equipment itself there are a lot of deficiencies. First is crushing effect the striking surface of the hammer focus of attack, crushing poor. Again, hammerhead is monolithic hammer wear and must be replaced as a whole, high maintenance costs, the maintenance operation is more complicated life of only one or two days, a hammerhead. Finally, there is the capacity can not be greatly improved, and can only be applied to small mines. If the miners need to increase productivity, the single line of production capacity in excess of fifty or sixty tons, continue to hammer crusher inappropriate. Hammer crusher crushing operations to complete the larger production very reluctantly, will lead to wear of the high cost, frequent maintenance passive situation.

In conjunction with the customer's specific requirements and the actual situation, YIFAN machinery for its recommended cone crusher, cone crusher is typical laminated crushing equipment, the biggest feature is the use of wearable pieces relatively long period, usually three stage crushing cone crusher wear parts (rolling acetabular wall, crushing wall) can reach the service life of 6-12 months can save considerable cost of production, which the user is concerned, also greatly reduces the maintenance job amount. But there is a problem, cone crusher, the price is relatively high, and higher investment costs.

The customers in order to obtain higher profits, the best way is to improve production efficiency, reduce production costs, and thus recognized Division I program. YIFAN its design program for rough crusher: PE600 × 900 jaw crusher, in breaking: two PEX 250 × 1000 jaw crusher, fine crusher: SMH1000 cone crusher. Whole iron production line the theoretical yield of 80-100t / h. The actual production has reached 100t / h, since the run for more than a month, without any problems. Customers are quite satisfied.

Customers complement by SMH1000 cone crusher crushing material is basically in the 20-30mm than before using the hammer to break the granularity of the material is also stable. Multi-broken the less grinding technology advantages in high efficiency composite cone crusher embodied most vividly. The biggest benefit or people save time and effort worry.